Dataman 530 Series - Manual (Page 13)

Development kit for DATAMAN 530
Programmer’s Guide
Parameters:
OnOff – indicates, whether the output is turned on or off
ONOFF_ON – turns output on
ONOFF_OFF – turns output off
Return value: -
3.3.5. SetFilter
Sets selected filter on the output.
void __declspec(dllimport) __stdcall SetFilter(int filter);
Parameters:
filter – indicates filter to be connected to the output
FILTER_NO – no filter
FILTER_40MHZ – 40MHz filter on the output
FILTER_20MHZ – 20MHz filter on the output
Return value: -
3.3.6.SetFrequency
Sets the frequency on the output. If the arbitrary waveform length is selected
this function sets the sampling rate. Otherwise it sets the waveform frequency.
double __declspec(dllimport) __stdcall SetFrequency(double freq);
Parameters:
freq – frequency (If the arbitrary waveform length is selected this parameter
indicates the sampling rate. Otherwise it indicates the waveform frequency.)
Return value:
Frequency that was set to the device.
3.3.7. SetShift
Sets shift of the waveform.
void __declspec(dllimport) __stdcall SetShift(double shift);
Parameters:
shift – indicates the level of the 2048 quantization level in volts
Return value: -
3.3.8. SetTriggerMode
Sets trigger mode.
- 13 -