Drylam Fujipla ALM3222 - Manual (Page 29)

AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page 29 of 63
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
19. Test for film curl. This is important. If film will not exit the machine in a “flat” state there may be jams and
wraparounds occurring when the machine is run in “automatic mode”.
If not already done, push the manual MOVE switch forward until about one (1) foot of film has exited the
laminator. Then, using a pair of scissors cut the laminated film at a point approximately three (3) inches out
from the laminator. Be sure to identify the upper side of the film from the lower side of the film.
NOTE: The laminator is not ready for automatic mode if film is hanging out the discharge. Always press the
CUT button and pull the waste of out the machine to ready for automatic mode.
1inch
Upper side
Lower side