DT Videolabs RecordPro - Manual (Page 3)

Page 2
RecordPro Users Guide
Adding Tracks:
To add a track, click Add Video Track or Add Audio Track. Once added, the track’s settings
window will appear. Use the Sources tab to select from different sources. Use the
Compression tab to change codec and compression settings.
RecordPro will automatically choose the settings native to the capture device. These
generally work best, but may be altered if needed. It is very important to note that changing
from the device’s native settings requires extra processing, depending on the codec and
setting used. Make sure the machine is capable of handling this extra processing to avoid
dropped frames.
When setting up an audio track, make sure that you assign channel labels. Typically you will
set Channel 1 to left, and Channel 2 to right. Disable any unused tracks.
When finished, click Okay.
RecordPro automatically saves the last track’s settings and when launched, will revert to
those settings if the capture devices are still available.
To save or load various configurations, see Saving and Loading Settings below.
Removing Tracks - Highlight track and click Remove.
Changing Settings - Highlight track and click Settings.
Saving and Loading Settings - After configuring tracks for a specific device, click Save
Capture Settings. To re-load saved configurations, click Load Capture Settings.
Important Note:
RecordPro should be closed when using PlaybackPro, particularly when using the capture
device’s audio output for PlaybackPro.