Future Automation UBLS - Manual (Page 21)

In
st
all
at
io
n
: I
R
C
on
tro
l
Page 20 of 24 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
UBLS - Under Bed Lift Swivel
Operation Details
DC1
Low voltage power output for motor drive.
LED’s to show operation of limit switches
and positional counters
Mains Voltage Input
IR LED
IR Input Jack
RS232
Contact Closure



 

 


SLQV
RS232
- Use an RJ25 connector
in the socket marked
RS232 on the control box
to operate using RS232
Details
Baud rate: 9600
Stop bit:
1
Parity: None
Databits: 8
Pin 1: RX
Pin 6 : TX
Pin 3 & 4: GROUND
Pin 2: TX
Pin 3: RX
Pin 5: GROUND
IMPORTANT
Ensure protocol is entered exactly as written, including Carriage Return (Enter / ASCII 13).
RJ25 9 PIN D
PIN 1: RX TO PIN 2: TX
PIN 6: TX TO PIN 3: RX
PIN 3: GROUND TO PIN 5: GROUND
PIN 4: GROUND TO PIN 5: GROUND
PROTOCOL ACTION
fa_in Carriage Return (Enter ) Device IN
fa_out Carriage Return (Enter ) UBLS OUT no movement to swivel
fa_right Carriage Return (Enter ) UBLS OUT RIGHT limit
fa_left Carriage Return (Enter ) UBLS OUT LEFT limit
fa_preset Carriage Return (Enter ) UBLS to PRESET memory position
fa_stop Carriage Return (Enter ) STOPS the device at any position