Interspace Industries Indicator2 - Manual (Page 3)

6
Environmental
WEEE and RoHS Compliance. Indicator 2 and its associated accessories have been manu-
factured and sold in accordance with the requirements of the EC WEEE and RoHS direc-
tives. Please return all end-of-life items to your supplier, or Interspace Industries directly, for
appropriate disposal.
Packaging Materials:
Cardboard box: Grade 150 K/T ‘B’ (Single Walled Corrugated - Brown Kraft)
Protective Foam: Grade HLB 22 Grey Foam (High Load Bearing)
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
Operating Instructions
Unpacking and Connections. Unpack the main unit and place on a flat surface within easy
access for the Operator (see Fig 1). Adjust the angle of the main unit by loosening the
bracket securing fasteners on each side of the main unit and re-tightening once the most
comfortable angle is achieved.
Position each display lamp for best viewing and connect them to the main unit using 3-pin
XLR (mic) cables. Typical operating distances can be as much as 100m (300ft).
Note: Additional lamps (up to 2 per output) can be added to the system using standard mic
cable splitters (3-pin XLR type), thereby providing multiple displays located on more than one
lectern for example. The sum of the total distance between all displays and the main unit
should not exceed 100m (300ft) however.
Connect the IEC power cable to Indicator 2 and switch on the power at the source.
Basic Operation. Momentarily pressing any of the coloured buttons on the front panel of the
Indicator 2 will cause the display lamps to illuminate in that colour. The lamp will remain illumi-
nated in that colour until either the same button is pressed again (this turns off the display
lamp), or, an alternative coloured button is pressed on the front panel of the main unit.
3
Introduction
Indicator 2 is the AV professional’s best friend when it comes to controlling
a live event. Signalling to presenters or crew to ensure everything runs to
time is the key to a smooth, professional show and Indicator
2 is a simple
and effective ‘Traffic Light’ system.
Using everyone’s understanding of Green, Amber and Red signals,
Indicator
2 silently prompts presenters when to speak (green light), when to
summarise (amber light) and when to finish (red light). The main control
unit has dual indicator power outputs so that two lamps can be located for
easy viewing, or to cue more than one presenter or crew at the same time.
The indicator display lamps are self-contained and are connected using
standard 3-core XLR (mic) cables. Operation is by the main unit front
panel. Cable lengths can be in excess of 100metres (300 ft).
Live Event Timekeeping Made Simple!
We hope Indicator
2 exceeds your expectations and welcome any
feedback that you have about this or any of our products.
Thank you.
The Interspace Industries Team
www.interspaceind.com