KLING & FREITAG K&F NOMOS XLS - Manual (Page 14)

User's manual K&F NOMOS XLS
KLING & FREITAG GMBH © 2014 Version 1.2 Page 14 of 21
5.5 Cardioid Configurations with different Speakers
NOMOS XLS are suitable for cardioid configurations with certain K&F speakers. A chassis ratio
of 1 to 2 should be maintained within these configurations.
The speaker with one chassis should be standing on the floor and directed to the rear while
the speaker with two chassis directs to the front.
1 x NOMOS XLS under NOMOS XLT
standing
6. Fuse in the NOMOS XLS
To increase the operating safety of the NOMOS XLS, the subwoofers are equipped with fuses
at the signal input. These fuses reduce the risk of consequential damage resulting from a
short circuit (i.e. charred cables / connectors / fire damage).
When the fuse is burned out, then the chassis is most likely already ruined, as the fuse just
prevents consequential damage resulting from a short circuit of the chassis. A replacement of
the chassis is, therefore, unavoidable.
6.1 Replacing the Fuses
The fuse holder is behind the terminal.
Warning
Replace the fuse with the following original fuse only:
Bussmann S 506-8A, T 250V
Required tools:
• 2.5 mm Allen key for loosening the terminals
Instructions:
1. Loosen the four screws on the terminal.
2. Carefully pull the cables out of the speaker enclosure.
3. Open the fuse holder.
4. Replace the blown fuse.
5. Push the cables carefully back into the enclosure.
6. Pay attention to the correct alignment of the terminal.
Screw the terminal back on.