Protecting the speakers / operating safety, Stacking the subwoofers, 2 protecting the speakers / operating safety – KLING & FREITAG K&F NOMOS XLC User Manual
Page 7
User's manual
K&F NOMOS XLC
KLING & FREITAG GMBH © 2014
Version 4.2
Page 7 of 20
Make sure that the stacking feet of subwoofers stacked on top of one another are securely
positioned in the grooves of the lower speaker.
If you place a top speaker on a NOMOS XLC you must always strap the speakers to one
another and secure them from falling over.
4.2
Protecting the Speakers / Operating Safety
NOMOS XLC speakers may only be used in combination with a K&F SystemRack.
5System Requirements for Use
In general, audio signals must not be overdriven. This may be caused by mixing consoles,
equalizers, effect equipment, etc. and should be indicated on this equipment. When a power
amplifier is overloaded at the output (clipping), then the amplifier activates a clipping
warning signal. In any case, the signal must be reduced as soon as it sounds unnaturally
distorted.
The following signals may damage the speakers:
•
permanent high-level signals with high frequency and continuous noise from feedback.
•
permanently distorted high-level signals.
•
noises, which occur when the amplifier is on while equipment is being connected,
disconnected or switched on.
Do not install devices in any of the following places:
•
where the devices are permanently exposed to direct sunlight.
•
where the devices are exposed to high moisture or rain.
•
where the devices are exposed to strong vibrations and dust.
•
where low air circulation (convection) prevails.
•
that have a small distance to a wall.
Damage caused by the speakers' magnetic fields
Speakers are permanently surrounded by a magnetic field, even when they are not
connected. Therefore, during transport and placement of the speakers, it is important to
ensure that there is always approx. 1 m between the speakers and magnetic data media and
computer/video monitors.
For damage caused by
•
overloading the speakers
•
using the speakers without K&F SystemRack
we do not assume warranty and excludes liability for possible consequential damage.
5.
Stacking the Subwoofers
1.
Securely place the bottom subwoofer onto a level surface.