KLING & FREITAG K&F GRAVIS 12+ XW - Manual (Page 12)

User's manual K&F GRAVIS 12+
KLING & FREITAG GMBH © 2015 Version 3.5 Page 12 of 29
Push the release button A and
completely insert the lifting pin into
the flying point B. Let go of the release button when you
have completely inserted the bolt so
that the release button pops back up.
Ensure that you cannot pull out the
lifting pin any more.
Tip
To fly the speakers or mount them on the wall or ceiling, we recommend using the accessory
'Adjustable Speaker Mount GRAVIS 12' or 'U-Mount Wall / Ceiling Bracket GRAVIS 12'.
By using these accessories, you can easily adjust mounted speakers to the desired position.
4.1 Securing the Speakers (Secondary Safety Device)
The flying and securing point K&F 'VariPoint', the K&F 'eyebolt' and the K&F Lifting Pin are
suitable for securing a secondary safety device according to the German safety regulations
BGV C1.
Please heed the following specifications:
wire length wire diameter
max. falling
height
Wire rope
according
to DIN EN 56927
1m 5mm 0.2m
Major Saveking
®
safety wire
0.6m 3mm 0.2m
5. Rotating the high frequency horn
When operating upright, the GRAVIS 12+ N has a standard practice-orientated coverage
characteristic of 65° x 50° (hor. x vert.), the GRAVIS 12+ XW has 90° x 50° (hor. x vert.). When
you use it as a stage monitor, you have a good coverage into the depth of the stage and
an optimal lateral sound field boundary on the stage. For special uses, the horn can also be
rotated.
If you wish to rotate the horn, proceed as follows:
1. Remove the screws with a 2.5 mm Allen key.
2. Remove the front grille.
3. Remove the horn screws with a 3 mm Allen key.
4. Turn the horn by 90°.
5. Screw on the horn tightly again.
6. Mount the front grille with the 6 grille screws.
5.1 Required Tools
To rotate the high frequency horn:
• 2.5 mm Allen key for loosening the front grille
• 3 mm Allen key for loosening the horn tweeter