NEXCOM NEX 609 User Manual
NEXCOM Hardware
Advertising
Table of contents
Document Outline
- Preface
- Copyright
- Disclaimer
- Acknowledgements
- Regulatory Compliance Statements
- Declaration of Conformity
- RoHS Compliance
- Warranty and RMA
- Safety Information
- Installation Recommendations
- Safety Precautions
- Technical Support and Assistance
- Conventions Used in this Manual
- Global Service Contact Information
- Package Contents
- Ordering Information
- Chapter 1: Product Introduction
- Chapter 2: Jumpers and Connectors
- Before You Begin
- Precautions
- Jumper Settings
- Locations of the Jumpers and Connectors
- Jumpers
- CMOS Clear Select
- ME Clear Select
- LVDS1 Power Select
- LVDS1 Dimming Polarity Select
- LVDS1 CCFL/PWN Mode Select
- LVDS1 Dimming Voltage Select
- LVDS2 Power Select (optional)
- LVDS2 CCFL/PWN Mode Select (optional)
- LVDS2 Dimming Polarity Select (optional)
- LVDS2 CCFL Dimming Voltage Select (optional)
- AT/ATX Mode Select
- Connector Pin Definitions
- External Serial Port Connectors
- Internal Connectors
- ATX Power Input Connector
- CPU FAN Connector
- SYSTEM FAN Connector
- Power On/Off/Reset & PWR/HDD LED Pin Header
- RS232 Box Header Connector COM2
- RS232 Box Header Connector COM3
- RS232 Box Header Connector COM4
- GPIO
- USB 1 Connector
- USB 2 Connector
- USB 3 Connector
- Speaker-out Connector
- SATA Power Connectors
- LVDS Power Connector
- LVDS1 Connector A
- LVDS1 Connector B
- LVDS Power Connector (optional)
- LVDS2 Connector A (optional)
- LVDS2 Connector B (optional)
- Keyboard and Mouse Pin Header
- COM1B RI/5V/12V Supply Power Selection
- Block Diagram
- Chapter 3: BIOS Setup