Jumper settings, Voltage setup selection (sw3), Start-up mode / pre-heater control (sw2) – NEXCOM nROK 5300 User Manual

Page 28: Pci-104 vi/o voltage setting (jp4), Cmos input voltage select (sw1, jp5)

Advertising
Jumper settings, Voltage setup selection (sw3), Start-up mode / pre-heater control (sw2) | Pci-104 vi/o voltage setting (jp4), Cmos input voltage select (sw1, jp5) | NEXCOM nROK 5300 User Manual | Page 28 / 62 Jumper settings, Voltage setup selection (sw3), Start-up mode / pre-heater control (sw2) | Pci-104 vi/o voltage setting (jp4), Cmos input voltage select (sw1, jp5) | NEXCOM nROK 5300 User Manual | Page 28 / 62
Advertising
This manual is related to the following products:
See also other documents in the category NEXCOM Hardware: