Oklahoma Sound #MMC - Manual (Page 6)

6
Step 5:
a) ConƟnue by aƩaching panel #3 to the other
side of panel #5 by inserƟng the three cam
bolts on panel #3 in the cam lock holes on
the edge of panel #5. Once inserted all the
way and the two panels are flush Ɵghten the
cam locks to lock the two boards together.
b) Repeat the same process as above to aƩach
panel #7 to panel #3.
c) Once all the cam locks are properly Ɵght-
ened, cover them with cam cover #D to en-
hance the appearance.
Step 6:
a) IdenƟfy the base panel #6. The panel should
be place on a clean ,soŌ surface with the un-
derside facing upwards. You can idenƟfy the
underneath of the panel by idenƟfying the
four predrilled holes in each corner.
b) Proceed to aƩach one caster #J in each cor-
ner by using a Phillips screwdriver and screw
the caster to the base using four screws #I
per caster into the predrilled holes.
c) Be sure to aƩach the two locking casters clos-
er to the front of the base panel for easy ac-
cess to the brake while operaƟng the cart. To
locate the front of the panel, look at the sur-
face of the panel and you will noƟce that
there is only one edge that does not have two
pre drilled holes for dowels as shown in the
picture. That is the front edge of the base
panel.
d) ConƟnue by screwing in six cam bolts #A in
the surface of the base panel #4 as shown.