Proceed PAV - Manual (Page 65)

65
erasing memory buttons To erase the Memory Buttons, follow these steps:
1 Select the mode (AUD or SAT) in which you want to erase the
Memory button.
2 Press the corresponding Device button ( audio or sat ) and mute
button simultaneously. SET will appear in the LCD. Press the
Memory button to be erased. M(1-5)_## will appear in the LCD.
3 Press the channel + button. SAVE will flash in the LCD. The
Memory button is now erased.
NOTE: Any previously stored commands on a Memory button will be erased
when new commands are stored on the same Memory button.
changing the lcd display Twenty-four different LCD displays can be selected for each Device mode of
the remote control. To select an alternate LCD display, please use the following
procedure:
1 Press-and-hold the Device button for which you would like to
change the LCD setting.
2 While pressing the Device button, press-and-release the pause
button. Each time the pause button is pressed, the LCD will
show one of twenty-four displays.
3 Release the Device button when you find the new LCD display
you wish to assign to the Device mode.
• CHOICE OF LCD DISPLAYS
TV VCR CABLE SAT AUDIO CD
DVD AUX TV2 VCR2 TUNER AMP
TAPE1 TAPE2 WEBTV SURR DAT PROJE
AUX2 LD AUD2 LIGHT DSS AV
• LCD DISPLAYS IN THE AUTOMATIC AUDIO MODE
A-TV A-VCR A-CAB A-SAT AUDIO A-CD
A-DVD A-AUX A-TV2 S-VC2 A-TUN A-AMP
A-TA1 A-TA2 A-WEB A-SUR A-DAT A-PRJ
A-AX2 A-LD A-A2 A-LIT A-DSS A-AV