Q-See QSTD2408 - Manual (Page 48)

Digital Video Recorder User Manual
Notice: If you use a HTTP port other then 80, you need to add the port number after the IP
address. For example, if you set the HTTP port as 82, you need to enter the IP address as
192.168.0.25:82.
User name and password here are the same as that used on the DVR. The default
is admin and 123456.
6.1.2 Accessing the DVR on WAN (over the internet)
There are two ways that the DVR can be accessed over the internet.
1. Connect the DVR to internet through a router or virtual server.
STEP1
Input IP address, Subnet, Gateway. If using DHCP, please enable
DHCP in both the DVR and router. If using a static IP address for the DVR then
follow instructions in 6.1.1 STEP1
STEP2
Enter Video to set network video parameters like resolution, frame
rate etc.
STEP3
Forward IP address and port number in Virtual Server setup of the
router or virtual server. You can find instructions on how to do this in the router
manual. You can also find instructions for port forwarding for most popular
routers on the website
http://www.portforward.com . On this website click on the
orange “Routers” link in the second paragraph, then find the brand and model of
your router on the list and click on the link. On the next page click on the orange
“Default Guide” link, this will take you to the port forwarding instructions for your
router. Close firewalls in Windows and in the router if applicable.
STEP4
If you are using a dynamic IP address for internet access you may
want to use a dynamic domain name To do so you would need to apply for a
domain name in a DNS server supported by the DVR or router. Then add this
information to the DVR and router.
This DVR currently only supports
www.dns2p.com or www.88IP.net .
To enter the DNS information in the router, please check the router manual.
STEP5
Open IE browser, input IP address, or dynamic domain name and hit
enter. If HTTP port is not 80, add the port number after IP address or domain
name.
STEP6
IE will download the ActiveX control automatically. Then a window
pops up and asks for user name and password.
Notice: If you cannot download and install ActiveX, please r
efer to Appendix A FAQ Q7.
Input name and password correctly, and enter to view.
2. Connect the DVR to internet directly through ADSL or cable router.
STEP1
Get IP address, Subnet, Gateway information from your ISP and enter
it into the DVR. If using ADSL, please input user name and password, and click
OK. The DVR will connect to the server and show “connection succeeds”.
STEP2
Follow STEP4-7 of the connection method above.
44