Remote control, Open the battery cover of the remote control, Replace the battery cover – Q-See QSTD2408 User Manual
Page 13: 4 remote control
QSTD2400 Series DVR User’s Manual
2.4 Remote Control
The remote control uses two AAA size batteries and works after loading batteries
as follows:
STEP1
Open the battery cover of the Remote Control
STEP2
Insert batteries. Please make sure the poles (+ and -) are correct
STEP3
Replace the battery cover
Notice: If the remote control does not work, check the following:
1. Check the poles of the batteries.
2. Check the remaining charge in the batteries.
3. Check to see if the sensor on the remote or the DVR is blocked or dirty.
If it still does not work, Please contact Q-See to get a new remote control.
The layout of the remote control is shown in Fig 2.10 Remote Control
Fig 2.10 Remote Control
Item
Name
Function
1 Power
Button
Soft off switch to stop firmware running. Push it before
powering off the DVR.
2 INFO
Button
Get information about the DVR like firmware version,
HDD information
3
REC Button
To record manually
4
Number Buttons
Input numbers or choose cameras
5
Multi Screen Button
To choose multi screen display mode
6
SEARCH Button
To enter search mode
7
MENU Button
To enter menu
8
ENTER Button
To confirm the choice or setup
9
Direction Button
Move cursor in setup or pan/tilt/zoom (PTZ)
10
+/- Button
To increase or decrease the value in setup
11
Playback Control
Button
To control playback, Fast forward/rewind/stop/single
frame play
12
AUDIO Button
To enable audio output in live mode
13
Auto Dwell Button
To enter auto dwell mode
14
BACKUP Button
To enter backup mode
15
PTZ Control Button
To control PTZ cameras:
Move camera/ZOOM/FOCUS/IRIS/SPEED control
9