DVDO High Definition Video Processor & Hub Edge - Manual (Page 10)

Input Wizard: Step 2, Set Input Priority
Input Priority is used to select inputs if EDGE is set for Auto Input Select, which is the default. If one or more inputs has active signal,
EDGE will choose the active signal with the highest priority. You may use the Input Wizard to change priority as shown on this page.
2a. Set Input Priority
Input Priority is used to auto-
matically select inputs when
EDGE is in Auto Input Select
mode, which is the default.
If EDGE is in Auto Input
Select Mode, and multiple
inputs are powered on, then
EDGE will select the input
with the Highest Priority.
If you don’t want to change
Input Priority, press Down
Arrow to go to step 3.
2b. Change Input Priority
To change Input Priority put
the highlight bar over the
input you want to change
then press OK.
Use Down Arrow to move
the selection, then press OK
10