Supreme Audio SupremeAudio NAVIGATOR Series 7000 - Manual (Page 15)

14
E. Speaker Out (Please see the page 8)
1. This system could be connected to other speaker.
2. Use the Line In (E1) RCA jacks to input external audio sources, such as CD, or iPod. Turn
Master control to adjust the volume.
3. Use the Line Out (E2) with RCA jack to output the signal to other audio applications, such
as cassette recorder, or mixer.
4. Insert the mic cable (XLR or phone plug) into the Mic. In (E3) with XLR or phone jack to
use a wired microphone. Turn Mic. In (D4) to adjust to the proper volume.
F. Digital Echo System (Please see page 9)
1. Turn the power switch (H1-1) clockwise to turn on the echo system.
2. Turn the repeat button (H1-2) and delay button (H1-3) to adjust the echo effect required.
3. To use a wired microphone, insert the Mic. In (H1-4) and Mic. In 2 (H1-5). Adjust the
volume by turning Mic. 1(H1-6) and Mic. 2 (H1-7) clockwise to the proper position.
G. Audio Link System (Please see the page 9)
1. Turn the power switch (H2-8) clockwise to turn on the transmitter.
2. The LCD display (H2-2) will show “On” and then the channel number used last.
3. To select the channel, press the set button (H2-6) and the channel in LCD flash. Press up or
down button (H2-7) to select the channel to transmit, and then press set button again to
enter the setting.
4. Turn the volume control (H2-8) to the proper position.
5. When transmitting the signals, the TX indicator (H2-3) will light Green to show the
transmitting condition. The AF Level indicator lights Yellow (H2-4) to show the low
audio, lights Red (H2-5)to show the high audio.