Thuraya IP Voyager - Manual (Page 16)

16 • The Below Deck Unit BDU
BDU mounting information
1. The BDU can be mounted in either the horizontal or vertical position.
2. Install the BDU in a protected but ventilated area. Allow at least a 1-inch space
around top and sides to provide adequate cooling.
3. Mount the terminal onto a flat surface using at least four screws or bolts (not
supplied). Use screws or bolts with a diameter between 3.5 to 4mm. Vibration-
resistant screws or lock washers should be used.
Figure 2-1. BDU - mounting dimensions in mm.
Figure 2-2 BDU Wiring Diagram
Dimension BETWEEN Mounting Holes: 271mm
Dimen
sion
BETW
EEN
Mount
ing
Holes:
182.5
mm