Tru-Weld SC2400 Arc Welder - Manual (Page 20)

20
SC2400 Operations ‐ Settings
Setting Welding Controls ‐ Time and Current
The time and current controls are located on the front of the welder. The controls consist of a
Time Button, Current Button, Adjustment Dial, and a Fine/Coarse Switch. The digital display will
indicate the settings chosen during setup.
♦ When setting time or current, depress and hold down appropriate button, and turn Adjust‐
ment Dial clockwise or counter‐clockwise to the correct setting on the digital display.
♦ Use the Fine/Coarse Switch for setting the appropriate time or current ‐ this will toggle be‐
tween 10th’s and 100th’s of a unit (seconds or amps), depending on whether you are setting
Time or Current.
♦ There is a Chart (see below) of approximate settings for full‐base diameter studs located to
the left of the Controls.
Time Button
Adjustment Dial
Current Button
Fine/Coarse Switch
Digital Displays
DIA INCH TIME SEC AMPS DC DIA DEC DIA MM
1/4 0.200 500 .250 6.35
5/16
3/8
0.300
0.350
550
600
.312
.375
7.93
9.52
7/16
1/2
0.420
0.500
700
900
.437
.500
11.11
12.70
5/8
3/4
0.670
0.830
1200
1600
.625
.750
15.87
19.04
7/8
1
1.000
1.200
1800
2100
.875
1.000
22.22
25.40
3/4
7/8
.800 ‐ 1.4
1.0 ‐ 1.6
16‐1900
18‐2200
.750
.875
19.04
22.22
APPROXIMATE SETTINGS FOR THRU‐DECK WELDING