DTS 6 User Manual
Page 5
5
DTS SYSTEM TEST
13.
Unblock the timecode. Once the cinema processor automatically returns to a digital format, go into
the theater and listen to the sound track. Verify good sound quality and lip sync. Also verify no
extraneous noise during the quiet scenes.
14.
DTS-6D Programmed Default. Use the
SET-UP
DS1
disc to test all the default functions on the
player. Load the
SET-UP
DS1
disc in the DTS-6D and stand next to the unit when performing this test.
To start, allow the right channel’s pink noise to play in the theater. Eject the disc by pushing the
open/close button on the drive. The cinema processor should automatically pulse to the 04 (A-type)
format. Repeat procedure for the remaining formats as listed:
Pink noise channel
Default Format
Left
A-type (04)
Left
&
Right Surround
Non-sync
Center
SR (05)
Right
Mono (01)
DTS-6 Programmed Default. Use either the RevC or DS1 Setup disc to set levels. To check
default, eject the disc and verify the cinema processor automatically pulses to an optical sound
format. The DTS-6 system can default to either “A” type (04) or “SR” (05). This is determined by
jumper settings on external DTS logic boards.
D422 board,
INDEX SWITCH
, (push-button) behind the front panel plate