Dymo LabelWriter 400 Turbo - Manual (Page 32)

Using the Tape Editor
28
Designing a Label
In this section, we will show you how to print a label for a file folder tab using the Tape Editor. You
can format the label text and then save the label for future use.
When designing a label, the first items to consider are the width of the label tape onto which you
will print and the length of the area where you will place the label. For this example, we will create
a label that will fit on a file folder tab. The total label length must be no more than 3 1/2” (8.5 cm)
and we will print on label tape with a width of 1/2” (12 mm).
To create a label
1 Start DYMO Label Software.
The main window appears.
Label
Workspace
Rulers
Formatting
Toolbar
Designer
Toolbar
Tape Settings
Toolbar Save Open Print Paste New
Address
Book
Status
Bar
Buttons for
Label and Tape
Editor modes (if
both a tape and
a label printer
are installed)