Dodge 2010 Ram Chassis Cab - Manual (Page 179)

engine starting procedure for proper engine starting and
operating. Wait until the “Wait To Start Light” turns OFF,
then start the vehicle.
NOTE: The “Wait To Start Light” may not illuminate if
the intake manifold temperature is warm enough.
27. Odometer/Trip Odometer Button
Press this button to toggle between the odometer and the
trip odometer display. Holding the button in resets the
trip odometer reading when in trip mode.
28. Fuel Gauge
Shows level of fuel in tank when ignition switch is in the
ON position.
29. Low Fuel Warning Light
This light will illuminate when the pointer is be-
tween “E” and 1/8 indication mark (approximately
15% of tank volume) on the fuel gauge. When the
fuel gauge pointer is on “E” (equivalent to Distance To
Empty [DTE] = 0 on the overhead console, if so
equipped) there is reserve fuel capacity, which corre-
sponds to approximately 8% of tank volume. This reserve
capacity was put in place to prevent the likelihood of
customers running out of fuel when operating at maxi-
mum load conditions in areas where there are not many
fuel stations.
30. CRUISE Indicator Light
This light will illuminate when the electronic
speed control system is turned on.
ELECTRONIC DIGITAL CLOCK
The clock and radio each use the display panel built into
the radio. A digital readout shows the frequency and/or
time in hours and minutes (depending on your radio
model) whenever the ignition switch is in the ON or ACC
position.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 177