Dialogic 6.2 - Manual (Page 273)

General Information
November 2009 273
hooktimer_
minbreak
10 ms Minimum Dial Pulse Break
Time.
Shortest break region that is
counted as a dial pulse break
region. Anything shorter should
be ignored.
IISDN56_MINBREAK_TIMER_
DEFAULT (1)
1 ms
ign_insz_post_
rls_timer
10 ms Ignore Inseize After Release
Timer.
Time after the interface has
idled before Instant ISDN will
allow an inseizure from the
connected equipment.
IISDN56_IGNINSZ_TIMER_
DEFAULT (5)
50 ms
ign_rls_post_
ans_timer
10 ms Ignore Release After Answer
Timer.
Time after the call has been
answered before Instant ISDN
will allow the connected
equipment to try to tear down
the call.
IISDN56_IGNRLS_TIMER_
DEFAULT (5)
50 ms
modified_in_
rls_timer
50 ms Modified Incoming Release
Timer.
Timer started at answer that
determines when modified
incoming release filter timing
ends and normal incoming
release filter timing begins.
IISDN56_MOD_INRLS_TIMER_
DEFAULT (10)
500 ms
modified_out_
rls_timer
50 ms Modified Outgoing Release
Timer.
Timer started at answer that
determines when modified
outgoing release filter timed
ends, and normal outgoing
release filter timing begins.
IISDN56_MOD_OUTRLS_TIMER_
DEFAULT (10)
500 ms
no_ringing_
timer
50 ms Interval between rings during
the ring cycle on outbound calls
(FXS Loop Start and FXS
Ground Start calls only).
IISDN56_NO_RINGING_TIMER_
DEFAULT (80)
4 seconds
Table 13. Robbed Bit Signaling Timers (Continued)
Timer Granularity Definition Default Value