Maintenance – Dimplex DF3033ST User Manual
Page 17
17
Maintenance
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
Remove front glass assembly.
1.
upper bulbs are located in
2.
the upper left and upper right
corners of fireplace (Figure
8).
Remove the upper light cover
3.
for each bulb (two (2) Philips
screws each).
unscrew bulbs counter
4.
clockwise.
Insert new bulbs.
5.
Re-install upper light bracket.
6.
Replace glass assembly.
7.
Figure 9
Exploded view to show detail
Flicker Rod
Flicker
Motor
bulbs (3)
into the rubber bushing on the
flicker motor shaft (Figure 9).
unscrew bulbs counter
6.
clockwise.
Insert new bulbs.
7.
Reconnect the log set LED
8.
wire harness.
Install the log set by placing
9.
the front, bottom edge of the
ember bed in the track behind
the front panel. once in
place, push down on the back
edge of the ember bed until
the rear tab snaps into place
under the Partially Reflective
Glass (Figure 10).
!
NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
Replace glass assembly.
10.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
back
Ledge
Log
Ember bed
Rear
Tab
Side Section
Figure 10
Front
Edge