Amina ALF80 - Manual (Page 4)

Using the Adjustable Port System
02
The ALF80 features a unique port system allowing for greater flexibility when positioning and
concealing the product.
There are two optional positions where the port can be connected to the ALF80 cabinet. An aluminium
plate (port plate) and a rubber o-ring provide an air tight seal around the port. A similar blanking plate
is used to cover and seal the unused port hole.
To remove the port and blanking plates use a number 3 Hex screwdriver to remove the four fixing
screws. Then remove the plate from the cabinet taking care not to drop the o-ring through the port
openings.
To adjust the amount the port protrudes from the ALF80 cabinet, remove the screws along with the
port plate and pull/push the port by gripping the inside surface. Ensure the o-ring is correctly positioned
in its rebate before re-securing the port plate and make sure the port is absolutely firm. If it appears
loose, check the o-ring has not dropped through the opening.
Top Position
This port position can be useful if you need to stand the ALF80 on its end (connection terminal facing
upward), or when locating it in a ceiling void, port firing downward.
MAX 110mm