Anthony Gallo Nucleus Micro - Manual (Page 5)

3
6
Connecting your Nucleus Micro Satellites
5. For 2 channel stereo playback , connect your satellites to your subwoofer or another brand which
allows for high level inputs and outputs. You must also be able to adjust the crossover to only allow
frequencies of 80hz and above to go to the Micros. (preferably 100 or 120hz and higher) Going below this
frequency can cause damage to the speakers that may void the warranty.
6. For home theater use , There are two options.
Option 1 . Connect five satellites directly to the receiver and set all channels to the small enclosure setting.
Connect a powered subwoofer directly to the special subwoofer output on the receiver, usually called LFE
Option 2 . Connect the center and rear surround channels directly to the receiver and set to small
enclosure. Connect the front channels (left & right) to the subwoofer via the high-level speaker outputs.
The subwoofer will need to have an adjustable or fixed crossover that can be set to only allow frequencies
of 80 hz and higher at a minimum to go to the Micros. (preferably 100 to 120hz and higher) Once this has
been done, then connect the subwoofers high level inputs to the receivers speakers connections. It is very
important to always be consistent with the (+ & -) of the speaker wires to avoid phase problems. Wiring in
this manner will allow you to run the front left and right speakers at full range. (Large enclosure) A second
subwoofer could also be run off the LFE outputs of the receiver to further enhance the bass that is
increasingly more apparent in the digital recording era.
Caution ! For Home Theater Use:
Before playing speakers make sure that your receiver is set to “small” or crossed over at 80, 100 or 120
Hz. These satellites can not handle full range or “large” settings. If you do not do this, you may destroy
your speakers. Please follow all instructions in this manual.
Warranty Information
Our Nucleus Micro satellites do not have serial numbers, but are warranted to the original purchaser to be free
of manufacturing defects for a period of five years. To activate your warranty please fill out and return the
warranty card. A copy of the original dated bill of sale must be retained, as it will be required for any warranty
repairs.
Anthony Gallo Acoustics Limited Warranty
STATEMENT OF WARRANTY
We warranty this product to be free from all defects in material and workmanship for a period of five years.
This warranty extends to the original retail purchaser only, and not to subsequent purchasers or users of this
product. Warranty is only valid in country of purchase
This warranty will be void if:
1. Any defect in this product is the result of abuse, misuse, damage in transit, defective associated equipment,
faulty hook-up, the use of the speakers with equipment for which it was not intended or acts of God.
2. The unit has been operated contrary to instructions contained in the accompanying Owner’s Manual.
3. The unit has been serviced by unauthorized personnel.
All other warranties, express, implied or statutory, including but not limited to warranties of merchantability or
fitness, and all other obligations or liabilities of Anthony Gallo Acoustics are limited in time to the period of
warranty granted hereby.
Nucleus Manual Layout 4/10/02 9:11 AM Page 5