Anthony Gallo A'Diva - Manual (Page 6)

5
In addition to the A'Diva
we offer the following products:
Nucleus Micro™ , our 4-inch spherical loudspeaker can be used with an assortment of optional mounting
systems. The Micro is best enjoyed mated with our MPS-150 or MPC-1 subwoofers.
Impedance --- 8 ohms, Power handling -- 100 watts
The Micro is available in a wide range of colors: Matte Black / Matte White / High Gloss Black / Cobalt Blue /
Wine / Bronze / Yellow / Stainless
Optional Mounting Hardware --
MMW = Wall-mount bracket (Black or White)
MJB = Single gang box mount (Black or White)
MTM = Micro table mount (Black or White)
ST = Wallflower floor stands (Black, White or Stainless)
_____________________________
Due', our dual 4-inch sphere loudspeaker features our highly acclaimed CDT tweeter. The Due' comes
packaged with an integrated wall-mount bracket/pedestal stand. The Due' is best enjoyed mated with our
MPS-150 or MPC-1 subwoofers.
Impedance -- 4 ohms, Power handling -- 100 watts
The Due' is available in a range of powder-coated finishes: Matte White / Matte Black and Silver/Gray.
Optional Due' floor stands are available in Black, White or Silver/Gray.
_____________________________
MPC-1 Subwoofer , was, naturally enough, designed to compliment our Nucleus Micro™ A'Diva and Due'
satellite loudspeakers. And thanks to the efficiency of our patented S2 technology, this modestly sized
subwoofer can produce the deep and accurate bass of a much larger design. The MPS-150 is only available
in Matte Black
Please visit our website, http://www.anthonygallo.co.uk, to learn more about Anthony Gallo Acoustics' innovative
designs.
5
Standard Dolby Digital/DTS Receiver Set-Up
Directions if you are using our powered subwoofer-
Wire the LFE or Sub output of your receiver directly to the input on the subwoofer
Select “Sub On'' in the receivers “Set-Up Menu".
Next wire the A'Divas directly to the receiver's speaker terminals and select "Small Enclosure" in the
receivers "Speaker Set-Up Menu”.
If the receiver has adjustable crossover settings, you may want to experiment with the lower settings,
typically 80Hz, and the higher alternative of 120 Hz. We prefer the sound with the 80 (or 100Hz)
setting.
Directions if you are using our passive subwoofer.
Run the left and right main speaker wires from your receiver to the '”IN” connectors of the crossover.
Next run the left and right speaker wires from the "HIGH PASS ' or "OUT" of the crossover to the
connections on the A'Divas.
Select "Large Enclosure" in the receivers “Speaker Set-Up Menu". This will allow the low frequencies to
pass into the subwoofer.The “Small Enclosure” setting should be used for the center or rear speakers if
being connected to the A'Divas or Micros.
A'Diva Specifications
On-wall frequency response: 76-Hz--20-kHz.
Sensitivity: 88-dB
nominal impedance:8 ohms
Power handling: 50 watts full range/100 watts when used as a "small" speaker
Height on Wallflower stand: 37-inches
Driver: 3-inch full range
Crossover: None
Connectors: Gold-plated binding posts
Dimensions: 5-inch sphere
Weight: 3.5 pounds
Colors: High Gloss Black, White, Silver/Gray
Supplied accessories: Table mount stands, wall mounting hardware, and 20 feet of speaker cable
4