Aplex Technology APC-3918P User Manual
Page 17
APC-3918P User Manual
17
Open
NORMAL
(Default)
Close 1-2
Clear CMOS
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins1 and 2 for about 3
seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the <F1> or <DEL> key to enter CMOS Setup
Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
3. BAT1 :
(1.25mm Pitch 1X2 box Pin Header) 3.0V Li battery is embedded to provide power for
CMOS.
Pin#
Signal
Name
Pin1
VBAT
PIN2
Ground
4. DCIN:
(5.08mm Pitch 1x3 Pin Connector),DC9V ~ DC32V System power input connector。
Pin#
Power
Input
Pin1
DC+9V~32
V
Pin2
Ground
Pin3
Ground
Power Mode
Location
(5.4.4.)
Location
(5.4.5.)
Location (5.4.6.)
ATX