Argox AS-8020CL Quick Reference Guide - Manual (Page 3)

Revision V4 Nov 25 th , 2014
Disconnect with smart devices and reconnect to cradle
1. Power on the cradle
2. Scanner the PIN code label on the bottom of cradle
3. Scanner the Cradle Connection only barcode below
Cradle Connection only.
4. Enable cradle inquiry beep continuously (Default)
Related Parameter Settings
There are several related parameter settings for the AS-8020CL and AS-8520.

Cradle Connection only.
 Dongle connect to PC via serial port
and PIN code input is necessary for
each connect (*).
 Dongle connect to PC via serial port
and PIN code input is necessary for
the first connect only (*).
 Turn off HID re-connect from scanner
to PC
 HID re-connect duration from scanner
to PC (1AC01~1AC09
– 10sec ~
90sec).
Disclaimer
Argox makes no warranty of any kind with regard to this publication, including, but not
limited to, the implied warranty of merchantability and fitness for any particular
purpose. Argox shall not be liable for errors contained herein or for incidental
consequential damages in connection with the furnishing, performance, or use of this
publication. This publication contains proprietary information that is protected by
copyright. All rights are reserved. No part of this publication may be photocopied,
reproduced or translated into any language, in any forms, in an electronic retrieval
system or otherwise, without prior written permission of Argox. All product information
and specifications shown in this document may be changed without prior notice.
All rights reserved. Copyright © 2012 Argox Information Co., Ltd