Delta DP400 - Manual (Page 9)

9
6. Assemble the column (A) Fig. 6, to the base (B) using
the four M10x40mm hex head screws (C), three of which
are shown.
Fig. 6
7. Assemble table raising and lowering handle (D) Fig.
7, to worm gear shaft (E) and tighten screw (F) against
flat on shaft with 3mm wrench supplied.
Fig. 7
Fig. 8
8. Thread table clamp handle (G) Fig. 8, into hole in
rear of table bracket, as shown.
D
E
F
G
C
C
A
B