Dual XD1228 - Manual (Page 5)

5
XD1228 OPERATION
General Operation
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left
side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips
head screw through left side of mounting frame into
faceplate.
Press to turn the unit on. Inserting a CD will turn the unit
on automatically. Press and hold for three seconds to
turn the unit off.
Press MODE to select between AM/FM, CD or auxiliary
input. Modes of operation are indicated in the display.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
MODE to select AUX mode.
Adjust volume using the volume knob (00-46).
The radio frequency (tuner mode) and CD track/elapsed
time (CD player mode) will be shown by default. Press
DISP to display the clock, and press DISP again to return to
default display.
Press and hold DISP for 2 seconds, the clock will begin to
flash. Press TRACK
nn
to adjust the hours and TRACK
ll to adjust the minutes. Press DISP or wait 5 seconds to
save the clock settings.
The clock will display 12-hour AM/PM time in USA
frequency spacing mode (PM 10:00). In European frequency
spacing mode, the clock will display 24-hour time (22:00).
Press and hold for more than 2 seconds to RESET the unit
upon initial installation. The RESET button is located behind
the faceplate.
Faceplate Removal
Semi-permanent
Faceplate Installation
Power On/Off
Mode
Auxiliary Input
Volume
Display
Set the Clock
12/24-hour Clock
Reset