ART Pro Audio HPFX - Headphone Mixer/Amplifier - Manual (Page 4)

QUICK SETUP:
Plug the AC adapter into the back of the HPFX and then into a wall socket. Make sure that the
Stereo Mix Input Level switch (on the back of the unit) is in the out (Norm) position. You may
need to depress this switch later, after the other setup steps are done, if you are using a very
hot monitor signal. Set the front panel controls to 12 o’clock, as a starting point.
Connect your microphones to the XLR Mic INPUTS on the rear, and connect the THRU
outputs to your preamp or mixers mic inputs. Next connect your cue track or stereo signal that
you want to monitor, into the STEREO MIX INPUTs. Plug your headphones into the front jack
and you are done with the basic setup.
The following diagram details connections to the unit and shows the audio signal flow within
the HPFX. This is also printed on the top of the HPFX, for quick reference.
f f
- 4 -