Dodge 2008 RT Caravan User Manual

Page 190

Advertising
background image

Watch for the HomeLink

௡ indicator to change flash rates.

When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open and close while you train.

NOTE:

Some gate operators and garage door openers

may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.

NOTE:

After training a HomeLink

௡ channel, if the

garage door does not operate with HomeLink

௡ and the

garage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 “Programming A Rolling Code Sys-
tem.”

4. Press and hold the just-trained HomeLink

௡ button

and observe the indicator light.

If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink

௡ button is pressed.

If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, proceed to Step 5 “Pro-
gramming A Rolling Code System.”

5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.

This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).

188

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising
This manual is related to the following products: