ART Pro Audio Tube Channel - Tube Mic Preamp/Compressor/EQ - Manual (Page 23)

22
A R T Tube Channel Specifications
Dimensions 5.25"D x 19"W x 1.65"H
Weight 8.0 lb.
Maximum Gain
XLR to XLR 81dB
¼” to ¼” 63dB
Phantom Power +48v DC (switchable)
Compression Ratio 2.3:1 (comp)/ 6:1 (lim)
Attack Time 6.5ms
Release Time 200ms (fast), 70ms-1sec (auto)
EQ Frequency Bands:
Low Shelf: 40Hz/120Hz Selectable
High Shelf: 6KHz/18KHz Selectable
Low-Mid Sweepable: 20Hz to 200Hz/ 200Hz to 2KHz
High-Mid Sweepable: 200Hz to 2KHz/ 2KHz to 20KHz
“Q” 1.1
Gain/Frequency Band: +/- 12dB
Equivalent Input Noise -129dBu (XLR to XLR, ‘A’ wghtd)
Dynamic Range >90dB (no weighting)Input
Impedance 1.67k ohms (XLR), 1M ohm (¼”)
Output Impedance 600 ohms (XLR), 300 ohms (¼”)
Maximum Input Level +15dBu (XLR), +21dBu (¼”)
Maximum Output Level +27dBu (XLR), +22dBu (¼”)
CMRR 90dB (typical)
THD <0.1% (typical)
Tubes Two Hand-Selected Tubes
(12AX7A/12AT7)
Power Requirements 100-125 VAC, 25W (Export units
configured for country of
destination)
A R T retains a policy of constant product improvement. A R T reserves the
right to make changes in design or make additions to or improvements upon
this product without any obligation to install the same on products previously
manufactured. In other words, specifications are subject to change without
notice.
Designed and manufactured in the United States of America.
Applied Research and Technology, Inc. (716) 436-2720 (Phone)