ART Pro Audio Tube PAC - Tube Mic Preamp/Compressor - Manual (Page 6)

pression without hearing the compressor.
SSE ETTTTIIN NG G U UPP
U Un np pa acckkiin ng g
Your Tube PAC was packed with care at the factory. The shipping
carton was designed to protect it during initial shipment. Please
retain this carton for use in transporting the Tube PAC, or in the
unlikely event that you need to return your Tube PAC for servicing.
A AC C PPo ow weerr H Ho oo okku up p
The Tube PAC has an internal power supply designed to operate
at 100 to 125VAC, 50 to 60Hz. Units manufactured for use out-
side of the United States of America have been modified to com-
ply with the required electrical specifications. Under no circum-
stances should the power cable be altered. If the cable becomes
cut or damaged, discontinue its use and have it replaced before
operating the Tube PAC.
A Au ud diio o C Co on nn neeccttiio on nss
Audio connections to and from the Tube PAC are balanced XLR
(Pin 2 Hot (+), Pin 3 Cold (-), Pin 1 Ground) and unbalanced 1/4”
(Tip Hot (+), Sleeve Ground.) We recommend using only high-
quality cables equipped with the appropriate connectors.
IIn nsstta alllla attiio on n
The Tube PAC may be employed in a number of setups
including:
- Between a microphone and a mixer, digital multi-track recorder,
DAT machine, hard disk recorder, or analog recorder.
- In a mixer’s channel insert points.
- Between a microphone and signal processors.
- Between electronic musical instruments (synthesizers, guitars,
bass, samplers, acoustic instruments with pickups) and
other gear.
5