Artesyn ATCA-7350 - Integrating with Workbench User Guide (September 2014) - Manual (Page 18)

Building Kernel and Root File System Images
ATCA-7350 - Integrating with Workbench User Guide (6806800H90D) 18
14. Click Next to display the Indexer screen as shown below.
15. Click Finish to start the configuration of project.
16. On completion of the project configuration, the project name appears in the Project
Explorer pane.
17. In the Project Explorer, right-click the project name and select fs, build-all,
kernel_build, kernel_rebuild, or export-sysroot to build the respective component.
Note that before building kernel, it is mandatory to build the fs.
18. Right-click the appropriate component and specify the build target.
19. After performing the above steps, rootfs and kernel image for the target built (specified in
step 17) will be created under the export directory of project (specified in step 6).
In our example, the rootfs will be stored as emrsn_atca_7350-glibc_cgl-cgl-
dist.tar.bz2
in /home/wind/workspace/ATCA_7350_prj/export directory
and the kernel image is stored as emrsn_atca_7350-bzImage-WR2.0aq_cgl in
/home/wind/workspace/ATCA_7350_prj/export
directory.