Artesyn COMX-P2020 Installation and Use (July 2014) - Manual (Page 42)

Hardware Preparation and Installation
COMX-P2020 COM Express Module Installation and Use (6806800K97D) 42
Installing the COM Express Module on the Carrier Board
1. Line up the board-to-board connector of the COMX-P2020 COM Express Module
assembly with the board-to-board connector of the carrier board.
2. Make sure that the interconnectors are properly aligned and that the bottom
surface of the COMX-P2020 COM Express Module have contact with the four
standoffs on carrier board.
3. From the topside of the COMX-P2020 COM Express Module assembly, locate the
screw holes on heat spreader/cooler.
4. Use the screws to fasten the COMX-P2020 COM Express Module assembly to the
carrier board.
Removing the COM Express Module from the Carrier Board
1. From the topside of the COMX-P2020 COM Express Module assembly, locate the
four screws that connect the COMX-P2020 COM Express Module assembly to the
carrier board.
2. Loosen and remove the screws.
3. While holding the edges, pull the COMX-P2020 COM Express Module from the
carrier board.