Artesyn MVME2500 ECC Installation and Use (August 2014) - Manual (Page 110)

Boot System
MVME2500-ECC Installation and Use (6806800N30F) 110
3. Boot the MVME2500-ECC .
4. When prompted, press the "h" key.
U-Boot aborts the boot sequence and enters into a command line interface mode.
6.3 Boot Options
6.3.1 Booting from a Network
In this mode, U-Boot downloads and boots the Linux kernel from an external TFTP server and
mounts a root file system located on a network server.
1. Make sure that the
kernel, dtb,
and
ramdisk
are accessible to the board from the
TFTP server.
2. Configure U-Boot environment variables:
setenv ipaddr <IP address of MVME2500-ECC>
setenv serverip <IP address of TFTP server>
setenv gatewayip <gateway IP>
setenv netmask <netmask>
setenv bootargs 'root=/dev/ram rw console=ttyS0,9600n8
ramdisk_size=700000 cache-sram-size=0x10000'
saveenv
3. Transfer the files through the TFTP from the server to the local memory.
tftp 1000000 <kernel_image>
tftp 2000000 <ramdisk>
tftp C00000 <kernel dtb>
4. Boot the Linux from the memory.
bootm 1000000 2000000 c00000
Enter the command setenv bootdelay -1; saveenv to disable the U-Boot auto-boot
feature and let the U-Boot directly enter the command line interface after the next
reboot/power up.