4 serial port connector (com1/j1), 5 vmebus p1 connector, Table 3-12 – Artesyn MVME4100ET Single Board Computer Installation and Use (June 2014) User Manual
Page 62: Com1 port connector pin assignments, Table 3-13, Vmebus p1 connector pin assignments, Controls, leds, and connectors
Controls, LEDs, and Connectors
MVME4100ET Single Board Computer Installation and Use (6806800K76F)
62
3.3.3.4
Serial Port Connector (COM1/J1)
There is one front access asynchronous serial port interface (SP0) that is routed to the micro
DB-9 front-panel connector. You can use the Artesyn part MTCA-CONSOLE-CABLE to convert
to a DB9 male connector. The pin assignments for this connector are as follows:
3.3.3.5
VMEbus P1 Connector
The VME P1 connector is a 160-pin DIN. The P1 connector provides power and VME signals for
24-bit address and 16-bit data. The pin assignments for the P1 connector are as follows:
Table 3-12 COM1 Port Connector Pin Assignments
Pin
Signal
1
No Connect
2
RX
3
TX
4
No Connect
5
GND
6
No Connect
7
RTS
8
CTS
9
No Connect
Table 3-13 VMEbus P1 Connector Pin Assignments
Pin
ROW Z
ROW A
ROW B
ROW C
ROW D
Pin
1
Reserved (N/C)
D00
BBSY*
D08
+5V
1
2
GND
D01
BCLR*
D09
GND
2
3
Reserved (N/C)
D02
ACFAIL*
D10
Reserved (N/C)
3
4
GND
D03
BG0IN*
D11
Reserved (N/C)
4
5
Reserved (N/C)
D04
BG0OUT*
D12
Reserved (N/C)
5
6
GND
D05
BG1IN*
D13
Reserved (N/C)
6
7
Reserved (N/C)
D06
BG1OUT*
D14
Reserved (N/C)
7