Artesyn XMCspan Installation and Use (June 2014) - Manual (Page 18)

Hardware Preparation and Installation
XMCSPAN Installation and Use (6806800H03C) 18
2.2 Power Requirements
The XMCspan uses only +5.0 V from the VMEbus backplane. On-board power supplies
generate the required voltages for the various ICs. The XMCspan connects the +12 V and -12 V
supplies from the backplane to the PMC sites while the +3.3 V power supplied to the PMC sites
comes from the +5.0 V backplane power. A maximum of 15A of +3.3 V power is available to the
PMC sites, however the 90 W +5.0 V limit must be observed as well as any cooling limitations.
Requirement Operating Non-Operating
Temperature 0°C (32°F) to +55°C (+131°F)
This may be limited by the type of
hard disk used. -40°C (-40°F) to +85°C (+185°F)
Temperature Change +/-0.5°C/min +/- 1°C/min
Forced Air Flow - -
Relative Humidity 5% to 95% non-condensing at
+40°C (+104°F) 5% to 95% non-condensing at
+40°C (+104°F)
Altitude -300m to 3,000m -300m to 13000m
Vibration 0.1g from 5 to 100 Hz and back to
5Hz at a rate of 0.1 octave/minute 5-20 Hz at 0.01 g2/Hz
20-200 Hz at -3.0 dB/octave
Random 5-20 Hz at 1 m2/Sec3
Random 20-200 Hz at -3 m/Sec2
Shock Half-sine, 5g/11ms Half-sine, 15g/11ms
Free Fall 100 mm/3 axis 1,200 mm/all edges and corners
(packaged)