Auto-Zone Control Systems USB-Link 2 Technical Guide, Installation Instructions for the USB-Link 2 (Version 01E) - Manual (Page 17)

USB-Link 2
1 Technical Guide
USB Serial Converter and Serial Port
Driver Installation
The internal USB communication port of the USB-Link 2 uses a
specialized driver that must be installed on your Windows PC before
communication to the device can be established.
NOTE: You may already have this driver installed on your PC if
you are using a CommLink 5.
1. Before you begin, you must determine if your computer
is running 32-bit or 64-bit Windows. Open the System
information by clicking the
<Start> button, clicking
<Control Panel>, and clicking <System>. Under
System, you can view the system type. Based on what
type of system you have, you will choose 32_Bit.exe or
64_Bit.exe from the list of fi les shown in Step 5 .
2. Open the WM USB Drivers folder.
3. Copy and paste the folder “USBLink NewSS0073” to a
location on your computer’s hard drive.
4. Locate the folder “USBLink NewSS0073” on your hard
drive and double-click on it.
5. The following list of fi les will display. Choose 32_Bit.
exe or 64_Bit.exe based on what type of system you
determined you have in Step 1.
6. In the window that pops up, shown below, click <Next>
and the installation program will walk you through the
rest of the steps.
7. When successful installation has occurred, connect the
USB cable between the PC and the USB-Link 2. The PC
will automatically recognize the device and a COM port
will be assigned. Follow the procedures on the next page
to verify the Comm Port.
USB Driver Installation