Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) - Manual (Page 7)

USB-Link Technical Guide
7 Operator Interface
USB-Link USB Driver Installation for Windows
®
XP
8. Highlight the Win98_Win_2000_WinXP directory by click-
ing on it and then click <OK> .
9. The screen will now state, “Please wait while the wizard
installs the software...”
10. While the fi les are downloading, a Hardware
Installation Window might pop up as shown below. Click
<Continue Anyway> .
11. The wizard will then fi nish installing the software.
12. Once the wizard is done, click <Finish> .
USB Serial Port Driver Installation for
Windows
®
XP
1. Once the USB Serial Converter software is installed, the
Found New Hardware Wizard will appear again to down-
load the USB Serial Port software.
2. Follow steps 1 though 7 of the previously described USB
Serial Converter Installation instructions.
3. Click <Finish> when the wizard is done downloading the
software.
4. Windows ® XP requires you to restart your computer before
the new settings will take effect.
5. Continue with the next section “Finding What COM Port
Number the USB-Link is Using” on page 9.
Revised 6/14/11