Avalon Firestyles Tree of Life - Manual (Page 49)

Optional Equipment
(for qualified installers only)
49
© Travis Industries 4121128 100-01313
11. Remove and discard the screws (see “a” below) holding the stock regulator in place (see “b” below).
Remove and discard the stock regulator, spring, and gasket (see “c” below).
12. The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to
follow all of the directions. Place the stepper motor on the gas control valve (see below) – MAKE
SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor – tighten
to 25 Lb-inches. Leak-test this area after installation to verify proper installation. Route the stepper
motor wire near the IFC location.
a
T-20 Torx or
Slotted Screwdriver
b
c
d