Avalon Firestyles Olympic - Manual (Page 43)

Optional Equipment 43
© Travis Industries 93508061 4150520
Outside Air Installation (for wood stoves only)
This pedestal has an internal air duct that may be used to direct air to the combustion chamber. Follow
the directions below prior to installing the stove or attaching the pedestal.
Outside air is required for mobile home installations and in certain localities. Read the section "Outside
Air Requirements" on page 11 prior to installing outside air.
 Before placing the stove on the pedestal, determine the location of the hole that is cut through the
floor protection and floor. The illustration to the right details the location where this hole may be cut in
relation to the faceplate of the stove. Cut a hole at least 16 square inches in area that does not
interfere with structural members of the home.
 Place the included screen (or other screen) over the hole to act as a rodent barrier. It may be
attached above or below the floor. Secure the screen with the included staples.
 Prop the front of the stove up 12" and
pry out the outside air knockout with a
large screwdriver.
 The cover plate seals the area around
the air control rod. Remove the two
screws and bridge from the cover plate.
Slide the cover plate underneath the air
control rod and re-attach the bridge.
The hole for outside air
must fall underneath the
pedestal base.
19-3/4"
26"
The faceplate of the 1190 is 3/4" in front
of the front edge of the pedestal
Size of Pedestal Base
OUTSIDE AIR EQUIPMENT
Staples are used to attach
the screen to the floor.
Screen is used to prevent
rodents from entering.
Insulation is used to seal the side
edges of the pedestal .
Cover plate is used to
block off room air .
Outside Air Knock-Out
Drop Chute
Knock-Out
Rear Blower Knock-Outs
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
DO NOT REMOVE
FRONT OF STOVE
The cover plate has a clip which
attaches it underneath the air control.
Remove the two screws that hold the
bridge to the cover plate. Then replace
the bridge when the cover plate is in
place.
Air Control
Rod
Bridge
Phillips
Screwdriver