Delkin Devices MultiMedia Card to Floppy Disk Adapter - Manual (Page 4)

Inserting a MultiMediaCard
Insert the MultiMediaCard into the FlashPath with the gold contacts facing toward the
black plastic back and away from the metallic cover. Gently push the card until it is
flush with the edge of the FlashPath Adapter. (See figure 1)
Figure 1:
Inserting the
MultiMedia
Card
Figure 2:
Installing
New
Batteries
Metal face of FlashPath
Insertion slot on notched edge
Label side up;
Contact side down
Counter-clockwise to unlock
Clockwise to lock
Lithium button
battery (CR2016)
Page 2 Delkin Devices User’s Manual
Installing new Batteries in FlashPath
The FlashPath is packaged with batteries pre-installed. When the batteries run out,
replace them with new ones. Always replace both batteries at the same time.
1. Place the FlashPath on a flat surface with the black plastic surface facing up.
2. Gently press down on the battery cover, turning it counter-clockwise until the
notch on the battery cover aligns with the unlocked position. Lift the cover off.
Repeat for second battery cover.
3. Remove the old batteries and replace them with two CR2016 Lithium batteries.
Make sure that the (+) poles of the batteries face upward. Replace the battery
covers. (See figure 2)
FlashPath Floppy Adapter for MultiMediaCard
DDFLSPTH2-AD