Avery Dennison SNAP 656 - Manual (Page 33)

Users Manual Model 656/636 Control Panel Operation • •• • 27B
D O T S H I F T
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "CHANGE CUT POSITION" screen. This screen allows the
print position to be adjusted in the WEB direction. The <YES / NO> buttons are
used to change the new shift value. The value is displayed in a positive/negative
format. The value ranges for XX and YY can be from a -16 to a +16 dots. Pressing
ENTER will change the CURRENT DOT SHIFT value to the NEW DOT SHIFT
value. A more positive number will move the print to the front while a more negative
number will move the print to the back.
Pressing the MODE/Down Arrow key will take the user back to the "PRINT CHECK
OUT FORMAT" screen. Pressing the EXIT/Up Arrow key will take the user back to
the "HOME" screen.
PRINTHEAD SETUP
P R E S S E N T E R F O R
P R I N T H E A D S E T U P
This screen follows the "PRINT/CUT POSITIONS" screen.
Pressing ENTER will take the user to the "PRINTHEAD SETUP" screens. Pressing
the MODE / Down Arrow key will take the user to the "CALIBRATING SENSORS"
screen. Pressing the EXIT / Up Arrow key will take the user back to the "HOME"
screen.
C H A N G E S T R O B E
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen is the first screen under "PRINTHEAD SETUP" screen. This screen
allows the user to adjust the strobe. The <YES / NO> buttons are used to change the
new value. The value is displayed in a positive/negative format. The value ranges for
X and Y can be from a -7 to a +7. Pressing ENTER will change the CURRENT
STROBE value to the NEW STROBE value. A more positive number will make the
print darker while a more negative number will make the print lighter.
Pressing the MODE/Down Arrow key will take the user to the "CHANGE HEAD
CATEGORY" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
H E A D C A T E G O R Y
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "CHANGE STROBE" screen. The screen allows the user to
enter the head category. The <YES / NO> buttons are used to change the new head
category value. The value ranges from 1 to 8. Pressing ENTER will change the
CURRENT HEAD category value to the NEW HEAD value. See the section
“PRINTHEAD REPLACEMENT” for instructions for setting the head category.
Pressing the MODE / Down Arrow key will take the user back to the "CHANGE
STROBE" screen. Pressing the EXIT / Up Arrow key will take the user back to the
"HOME" screen.