Avery Dennison 9450 RASCAL Rev.AB 1/01 Quick Reference - Manual (Page 2)

To print in peel mode, continue with
the following steps.
6. Open the support frame by
squeezing the tabs on the frame
and pulling it forward.
7. Remove some labels from the
backing paper.
8. Feed the backing paper behind the
support frame.
9. Snap the support frame back into
place. Gently pull on the backing
paper to make sure it is tight.
10. Press [FEED] to calibrate the
supply.
Removing Supplies ------------------------------
Do Not back labels through the
printhead; it may cause a label jam.
1. Remove the supply holder.
2. Cut or tear supplies as close to the
supply guide, and remove the roll.
3. Push the printhead lever up and
turn the knob clockwise to feed the
supply out the supply chute.
Clearing Jams --------------------------------------
If supplies jam during printing, the
LED blinks, alternating between amber
and green.
1. Turn the printer off and remove any
supplies.
2. Grab the printer firmly with one
hand and with the other hand,
slide out the supply guide as
shown.
Do Not pull supply guide completely
out of the printer.
3. Remove the jammed supply using
only your fingers.
4. Clean the printhead.
5. Reload the supplies and turn the
printer on.
Cleaning ------------------------------------------------
Do Not touch the printhead with a
sharp object. This may damage it and
void your warranty.
1. Turn the printer off and remove
both the supply holder and the
supply roll.
2. Open the support frame.
3. Clean the printhead.
4. Push a cleaning card completely
through the supply guide and the
supply chute. Repeat as needed.
5. Clean the platen roller and peel
blade.
6. Open the support frame. Moisten
a cotton swab with isopropyl
alcohol. Rub it back and forth
across the platen roller and peel
blade to remove any buildup.
7. Let the printer dry briefly and
reload your supplies.
Jammed Label
in Supply Chute Supply
Guide
Platen
Roller
Peel
Blade
Support
Frame
Tabs
Backing
Paper
Label
FEED
Button