Baby Lock Crown Jewel (Previous Model) (BLCJ18) Instruction and Reference Guide Addendum - Manual (Page 7)

E. Attach the quilt back to the take-up rail
1. Unlatch the take-up rail so it turns freely and
unroll the take-up leader
2. Unlatch the backing rail so it turns freely
a) Bring the quilt back across the frame so it
reaches the take-up leader
b) Pin the quilt back to the take-up leader
1- Match the centers
2- Use the guide line on the leader to keep
the back straight
3- The wrong side of the quilt back faces up
F. Bring the batting up to lay on top of the quilt
back
1. Bring the batting to the front of the frame
between the backing and quilt top rails
Note: This makes sense since the batting belongs
between the quilt top and the quilt back
3. Re-engage the latches on both the take-up rail
and the backing rail
a) Turn the rails so the quilt back is stretched
firmly across the top of the quilt frame and
no longer sags loosely
a) Bring the batting up over the quilt back on
top of the frame
b) The leading edge of the batting should be
just below the pins in the quilt back
2. Use a channel lock to stitch a straight line
across the top of the batting
a) This line of stitching will serve two purposes
1- The batting will be anchored to the quilt
back
2- You will have a nice straight line that
can be used to position the quilt top
3. Set up to channel lock
a) Position the Crown Jewel so the needle is
at the left end of the line to be sewn
b) Place the optional channel lock
(part #BLJ18-CL) over the wheel of the
machine as shown in the picture below
6
(e)