Dish Network Platinum DishPVR 501 - Manual (Page 13)

121716 11
4. Press the 0 number button.
5. Press the POUND ( # ) button.
The TV mode button flashes three times.
6. Press the SAT mode button.
7. Press the plus (+) and minus (-) sides of the VOLUME
button.
The TV’s volume changes and the
TV mode button lights
instead of the AUX mode button.
R EMOTE C ONTROL B UTTONS
C ONTROL THE R ECEIVER
S AT M ODE B UTTON
Press this button to set the remote to SAT (“satellite”) mode to control
the receiver. The SAT mode button’s back light stays lit for about two
seconds to show you’ve set the remote to SAT mode. Make sure you
keep the remote in SAT mode to use the buttons described here.
TV/V IDEO B UTTON
If you connect the receiver with its back panel TV ANTENNA/CABLE
IN and TV SET OUT ports, use this button to switch the receiver
between the satellite signal (connect it to the SATELLITE IN port) and
another video signal like a cable or broadcast TV antenna input
(connect it to the receiver’s
TV ANTENNA/CABLE IN input).
Note : If you connect the receiver to other devices with the phono
(RCA) jacks or the S-VIDEO output, you must use the TV
menus to change the input from local broadcast TV to satellite
TV.
text_dishpvr.fm Page 11 Friday, February 28, 2003 1:22 PM