Baumatic BHG900.5SS - Manual (Page 15)

15
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each
burner, which is designed to stop the flow of gas to the burner head in
the event of the flame going out.
To ignite a burner:
o
Press in the control knob of the burner that you wish to light and
turn it anti-clockwise to the maximum position.
o
If you keep the control knob depressed, the automatic ignition
for the burner will operate.
o
You should hold down the control knob for 20 seconds after the
flame on the burner has lit.
o
After this 20 second interval, to regulate the flame you should
continue turning the control knob anti-clockwise until the flame
is at a suitable level. The operating position MUST be at a
position between the maximum and minimum position.
o
To switch the burner off, turn the control knob fully clockwise to
the gas off position.
o
In case of power failure, the burners can be lit by carefully using
a match.