Baumatic BDWI660 - Manual (Page 33)

33
General troubleshooting
PROBLEM POSSIBLE
CAUSES
WHAT TO DO
Dishwasher
doesn’t start. Fuse blown or the circuit
breaker acted.
Power supply is not
turned on.
Water pressure is low.
Door of the dishwasher is
not properly closed.
Replace the fuse or reset the
circuit breaker. Remove any
other appliances sharing the
same circuit with the
dishwasher.
Make sure the dishwasher is
turned on and the door is closed
securely.
Make sure the power cord is
properly plugged into the wall
socket.
Check that the water supply is
connected properly and the
water is turned on.
Make sure to close the door
properly until it latches.
Water does
not drain from
dishwasher.
Kink in the drain hose.
Filter clogged.
Kitchen sink is clogged.
Check the drain hose.
Check the coarse filter.
Check the kitchen sink to make
sure it is draining well. If the
problem is the kitchen sink not
draining, you may need a
plumber rather than an engineer
for the dishwasher.
Suds in the
dishwasher.
Improper detergent was
used.
Spilled rinse-aid.
Use only specific dishwasher
detergent to avoid suds. If this
occurs, open the dishwasher
door and let the suds evaporate.
Add 1 gallon of cold water to the
interior and close the door.
Select the RAPID program with
no dishes loaded and allow the
dishwasher to drain the water.
Repeat if necessary.
Always wipe up rinse-aid spills
immediately.
Stained
interior. A detergent with
colourant was used. Make sure that the detergent
used is one without colourant.
White film on
interior
surface.
Hard water minerals. To clean the interior, use a
damp sponge with an
appropriate dishwasher descaler
and wear rubber gloves.
Never use any other cleaner
than those specifically for